810 Resin and Metal Drip Tip - Marbled Effect with Spare O-Rings

This 810 resin and metal drip tip gives a tank or atomiser a fresh look with its marbled effect finish. It suits anyone who wants to replace a worn drip tip or simply change the appearance of their setup, and it comes with spare O-rings.

Key features

• 810 drip tip fitting
• Resin and metal construction
• Marbled effect finish
• 1 x single drip tip
• Spare O-rings included

The combination of resin and metal gives the drip tip a decorative look. Because the marbled effect is a pattern, the exact swirls on each drip tip can vary slightly. The spare O-rings are handy if the original ring wears out or goes missing.

What's in the box

• 1 x 810 resin and metal drip tip
• Spare O-rings

How to use

1. Remove the existing drip tip from your device, if there is one.
2. Check that the O-ring is seated properly on the new drip tip.
3. Push the drip tip firmly and evenly into the 810 socket until it sits snugly.
4. Wipe it clean from time to time and replace the O-ring if it loosens.

FAQs

Will this drip tip fit my device?

It is an 810 drip tip, so it is intended for tanks and atomisers with an 810 drip tip socket. Check your device's drip tip size before ordering.

Does it come with spare O-rings?

Yes, spare O-rings are supplied with the drip tip.

How many drip tips are in a pack?

Each listing is for a single drip tip.

Will every drip tip look identical?

Marbled finishes are patterned, so small differences in the swirls are normal.