Imp Jar SELECT 0.8 Ohm Mesh Replacement Pods - Pack of 2

These Imp Jar SELECT replacement pods are a pack of two empty, refillable pods for the Imp Jar SELECT 10K device and starter kits. They use a 0.8Ω mesh design made for mouth-to-lung (MTL) vaping with nic salts, so they suit anyone who already uses the device and wants spares ready to go.

Key features

• 0.8Ω pods with an MTL design
• 2ml capacity per pod
• Manual top-fill port
• Clear pod body, so you can see the e-liquid level
• Push-fit install
• Supplied as a 2-pack

The 0.8Ω MTL design is intended to suit nic salt e-liquids. The top-fill port and clear body keep refilling simple, and the visible level shows when it is time to top up. Fitting is push-fit, so swapping a pod takes seconds.

What's in the box

• 2 × Imp Jar pods (0.8Ω, 2ml)

Compatibility

• Imp Jar SELECT 10K device and starter kits
• Pairs with Imp Jar SELECT 10ml bottles, which are stored in the device compartment

How to use

1. Push the new pod firmly into the device until it is seated.
2. Fill the pod through the top-fill port with your e-liquid, staying below the top of the pod.
3. Leave the pod to soak for a few minutes before your first puff so the wick can absorb the e-liquid.
4. Check the level through the clear pod body and top up when it runs low.

FAQs

Do these pods come filled?

No. They are supplied empty, and you fill them yourself through the top-fill port.

How much e-liquid does each pod hold?

Each pod holds 2ml.

Which device do they fit?

They are made for the Imp Jar SELECT 10K device and starter kits.

What e-liquid should I use?

The 0.8Ω MTL design is intended for nic salts. They pair with Imp Jar SELECT 10ml bottles, which store in the device compartment.