Innokin T18E & T22E Mesh Coils 1.6 Ohm - Pack of 5

These Innokin T18E and T22E mesh coils are replacement coils for the Innokin Endura T18E and T22E tank. Each pack holds five 1.6 ohm mesh coils, so you can keep spares ready for when your current coil needs changing.

Key features

• 1.6 ohm mesh coil version
• Made for the Innokin Endura T18E and T22E tank
• Suits the TPD compliant versions of the kits
• Sold in a pack of 5

The most important point is fit. These coils are made for T18E compatible devices only, so check what you own before ordering.

Compatibility

• Innokin Endura T18E tank
• Innokin Endura T22E tank

These coils are not compatible with standard T18 and T22 kits. If your device is a standard T18 or T22, these will not fit.

How to use

1. Switch off the device and empty or set aside the tank as needed.
2. Remove the old coil and screw or press the new one into place, following the instructions for your tank.
3. Put a few drops of e-liquid on the coil's openings and let it soak for a few minutes before first use.
4. Refill the tank, wait a little longer, then start with a few gentle puffs.

FAQs

Will these coils fit the standard Innokin T18 or T22?

No. They are made for the T18E and T22E tank and the TPD compliant versions of those kits only. They do not fit standard T18 and T22 kits.

How many coils are in a pack?

Each pack contains 5 coils.

What resistance are these coils?

They are 1.6 ohm mesh coils.

Do I need to prime a new coil?

Yes, as a general rule. Let a new coil soak in e-liquid for a few minutes before use so it does not get dry.