Smok LP1 Mesh MTL Coils 0.9 Ohm - Pack of 5

These Smok LP1 mesh MTL coils are replacement tank coils in a pack of 5, with a 0.9 ohm resistance. They suit anyone who already uses a compatible SMOK kit and wants spare coils on hand for mouth-to-lung vaping.

Key features

• Pack of 5 LP1 coils
• 0.9 ohm mesh coil designed for MTL
• Best wattage: 15W
• Triple silicone ring design for increased leak proofing
• Balanced heat distribution with a delicate flavour

The mesh construction is designed to spread heat evenly, which is where the balanced heat distribution and delicate flavour come from. The triple silicone ring design is there to improve leak proofing, so the coil sits snugly in your device. For the best results, run it at the recommended 15W.

Choosing your coil

This listing is for the LP1 0.9 ohm mesh MTL coil only, supplied as a pack of 5. These are designed for various SMOK kits, so check that your device uses LP1 coils before ordering. The coil code is usually shown in your device's manual or on the coil you are replacing.

How to use

1. Switch off your device and remove the tank or pod section.
2. Take out the used coil and fit the new one firmly.
3. Put a few drops of e-liquid onto the coil's wicking openings and let it soak for a few minutes before first use.
4. Refill the tank, reassemble, and take a few gentle puffs before vaping fully.
5. Set your device to around 15W if it has adjustable power.

FAQs

What wattage should I use with the LP1 0.9 ohm coil?

The best wattage for this coil is 15W.

Is this a mouth-to-lung coil?

Yes. It is a 0.9 ohm mesh coil designed for MTL vaping.

How many coils come in a pack?

Each pack contains 5 LP1 coils.

Why should I prime a new coil?

Letting a new coil soak in e-liquid before use helps the wick absorb fully, which avoids a dry, burnt taste on the first puffs.