Uwell Caliburn A3 Replacement Pods - 1.0 Ohm, 4 Pack

These Uwell Caliburn A3 replacement pods are made for the Uwell Caliburn A3 Pod Kit. Each pack contains four refillable 2ml pods with a 1.0 ohm FeCrAl mesh coil built in, so you can keep a spare or two to hand and swap when the flavour starts to fade.

Key features

• Designed for the Uwell Caliburn A3 Pod Kit
• Pack of 4 replacement pods
• 1.0 ohm resistance
• FeCrAl mesh coil
• 2ml capacity per pod

The coil is part of the pod, so replacing the pod replaces the coil too. There is no separate coil to fit. A four-pack is a practical way to stock up if the Caliburn A3 is your everyday device.

Compatibility

• Uwell Caliburn A3 Pod Kit

How to use

1. Remove the old pod from the device.
2. Fill the new pod with e-liquid, taking care not to overfill, then leave it to stand for a few minutes so the coil can soak.
3. Fit the pod firmly into the device.
4. Take gentle draws to start with, then vape as normal.

FAQs

Which device do these pods fit?

They are replacement pods for the Uwell Caliburn A3 Pod Kit.

How many pods come in a pack?

Four pods per pack.

How much e-liquid does each pod hold?

Each pod holds 2ml.

When should I change the pod?

Change it when the flavour turns dull or burnt, or when the vapour becomes weak. How often depends on how much you vape and the e-liquid you use, as very sweet liquids tend to wear a coil faster.