Vaporesso GTX Coils 0.2 Ohm Mesh - Pack of 5

These Vaporesso GTX coils in the 0.2 Ohm mesh version are replacement coils for the TARGET PM80, TARGET PM80 SE, GEN NANO and SWAG PX80. They come as a pack of 5, so you have spares ready when a coil needs changing.

Key features

• 0.2 Ohm mesh coil
• NiCr coil material
• Wattage range of 45-60W, with 55W listed as the best setting
• DTL (direct-to-lung) coil
• Pack of 5

The 0.2 Ohm GTX mesh coil is built for DTL use and runs between 45W and 60W. If you want a starting point, set your device to 55W and adjust within the range to suit your taste.

Compatibility

These coils are listed for use with:

• TARGET PM80
• TARGET PM80 SE
• GEN NANO
• SWAG PX80
• GTX Tank

How to use

1. Switch the device off and empty or set aside the tank before changing the coil.
2. Screw the new coil in firmly.
3. Fill the tank and let the coil soak for a few minutes so the wick is saturated.
4. Start at the lower end of the wattage range, then raise it if needed.

Replace the coil when the flavour fades or tastes burnt.

FAQs

Which devices do these coils fit?

They are listed for the TARGET PM80, TARGET PM80 SE, GEN NANO and SWAG PX80, as well as the GTX Tank.

What wattage should I use?

The coil is rated for 45-60W, and 55W is the listed best setting.

How many coils come in a pack?

Each pack contains 5 coils.

Why should I let a new coil soak?

Soaking lets the wick absorb e-liquid before you vape. A dry coil can taste burnt and wear out sooner.