Vaporesso GTX Mesh Coils 0.3 Ohm - Pack of 5

These Vaporesso GTX 0.3 Ohm mesh coils are replacement coils for the PM80 kit, GTX tank and SWAG PX80, supplied in a pack of 5. They suit anyone already using one of the compatible devices who wants a direct-to-lung (DTL) mesh coil to keep it running.

Key features

• Pack of 5 coils
• 0.3 Ohm mesh coil
• NiCr coil material
• Rated for 32-45W, with 40W given as the best setting
• DTL (direct-to-lung) coil

The wattage range is the most useful figure to note. Start around 40W, which is the setting recommended for this coil, and adjust within 32-45W to suit your taste. Keep within that range for the best results from each coil.

Compatibility

These GTX coils are listed for the following products:

• TARGET PM80
• TARGET PM80 SE
• GEN NANO
• XIRON
• SWAG PX80
• GTX Tank

Check that your device is on this list before ordering.

How to use

1. Remove the old coil and fit the new GTX coil firmly into place.
2. Fill the tank or pod with e-liquid and leave the new coil to soak for a few minutes so the wick is fully saturated.
3. Set your device within 32-45W, starting at 40W.
4. Take a few gentle puffs before settling into normal use.

FAQs

How many coils are in a pack?

Each pack contains 5 Vaporesso GTX 0.3 Ohm mesh coils.

What wattage should I use?

The coil is rated for 32-45W, and 40W is the recommended setting.

Is this a DTL coil?

Yes, it is listed as a DTL (direct-to-lung) coil.

Which devices do these coils fit?

They are listed for the TARGET PM80, TARGET PM80 SE, GEN NANO, XIRON and SWAG PX80, as well as the GTX Tank.

Do I need to prime a new coil?

It is good practice. Let a new coil soak in e-liquid for a few minutes before first use to help avoid a dry taste.