Voopoo DRAG 6 Sub-Ohm Vape Kit - 220W 2ml Tank

The Voopoo DRAG 6 sub-ohm vape kit is a high-power device for experienced vapers who want full control over their output. It pairs the Gene TT 3.0 chipset and a wide 5-220W range with a 2ml UFORCE-X tank, which is the UK TPD-compliant version.

Key features

• Adjustable power from 5W to 220W, with a maximum output voltage of 8.4V
• Gene TT 3.0 chipset
• Dual 2200mAh built-in batteries, 4400mAh in total
• 1.66-inch TFT display
• UFORCE-X tank with 2ml capacity and top-fill design
• Compatible with the full PnP X coil platform
• USB Type-C fast charging at 5V/3A
• Operating modes: SMART, RBA and TC-TRC (temperature control with preset wire types)
• Device resistance range of 0.05-3.0 ohm
• Kit dimensions of 150 x 51.4 x 28.6 mm

The 1.66-inch TFT screen shows your wattage setting, battery status and device information, so you can see where you are at a glance. With two 2200mAh batteries built in, the DRAG 6 has plenty of capacity for high-wattage use, and Type-C charging means you can recharge with a common cable. The tank has a stainless steel build with a glass tube, and filling is from the top.

What's in the box

• Voopoo DRAG 6 device
• UFORCE-X tank (2ml)
• Spare 2ml glass
• Two PnP X coils (0.15 ohm and 0.3 ohm)
• PnP X platform card

Compatibility

The UFORCE-X tank is compatible with the full PnP X coil platform, so you can swap between PnP X coils as you like. The tank also fits 510-platform devices.

Choosing your colour

The DRAG 6 is available in seven colours: Black, Blue, Brown, Green, Metal Grey, Red and Silver. The specification is the same whichever you choose.

How to use

Before first use, fit a coil and let it soak in e-liquid for a few minutes so the wick is fully saturated. Fill the tank through the top, then set your wattage within the range suited to the coil you have fitted (check the coil's own markings). Start at the lower end and adjust gradually. Charge the device with the Type-C port when the battery runs low.

FAQs

How big is the tank?

The UK version of the UFORCE-X tank holds 2ml, in line with UK regulations. A spare 2ml glass is included.

Which coils does it use?

It uses PnP X coils. The kit comes with a 0.15 ohm and a 0.3 ohm PnP X coil, and the tank is compatible with the full PnP X range.

How do I charge it?

Use the USB Type-C port. The manufacturer lists charging at 5V/3A.

What is the power range?

You can adjust output from 5W to 220W using the Gene TT 3.0 chipset.