Voopoo DRAG H40 Pod Mod Kit - 1500mAh 40W 2ml PnP Pod II

The Voopoo DRAG H40 pod mod kit is a compact device with a 1500mAh internal battery, a 40W maximum output and a 2ml PnP Pod II. It is aimed at advanced users who want adjustable power and airflow in a small body, with a coil design Voopoo calls Dual-In-One Tech.

Key features

• 1500mAh internal battery, charged by USB Type-C
• 5-40W output with RBA and SMART power modes
• Output voltage of 3.2-4.2V and a supported resistance range of 0.3-3.0 ohm
• 0.54" OLED display
• 2ml PnP Pod II made from PCTG, with a changeable drip tip
• Rotating, step-less airflow with two air inlets
• Zinc alloy and leather body
• Six built-in protections: overtime, output over-current, low battery, overheating, overcharge and atomiser short-circuit

In RBA mode you set the power yourself anywhere from 5W to 40W. In SMART mode the device works out a suitable output based on the resistance of the coil fitted. The PnP Pod II connects to the device magnetically, so it is quick to remove and refit, and you adjust the airflow simply by rotating the pod. The drip tip can be changed between a more MTL-focused draw and a DTL-focused draw. Voopoo describes the kit as designed for DTL vaping.

What's in the box

• 1 x DRAG H40 device
• 1 x PnP Pod II (2ml)
• 1 x PnP-VM3 coil (0.45 ohm, pre-installed)
• 1 x PnP-TW30 coil (0.3 ohm, spare)
• 1 x USB Type-C charging cable
• 1 x PnP Platform Card
• 1 x user manual

Compatibility

The kit uses the PnP Pod II and PnP coils. The pod is compatible with the full range of PnP coils, so you are not limited to the two supplied.

Choosing your colour

The Voopoo DRAG H40 is available in seven colours:

• Black
• Green
• Gun Metal
• Modern Red
• Pink
• Sky Blue
• Snow Blue

The specification is the same whichever colour you choose.

How to use your Voopoo DRAG H40 pod mod kit

1. Charge the device with the supplied USB Type-C cable before first use.
2. Fill the pod with e-liquid, keeping below the maximum fill line, and follow the instructions in the manual.
3. Leave a new coil to soak for a few minutes before vaping so the wick is fully saturated.
4. Choose RBA or SMART mode, then rotate the pod to set your airflow.
5. Replace the coil when the flavour fades or the vapour tastes burnt.

FAQs

Which coils come with the DRAG H40?

There are two: a 0.45 ohm PnP-VM3 coil already fitted in the pod and a 0.3 ohm PnP-TW30 coil as a spare.

How big is the pod?

The PnP Pod II holds 2ml.

Can I adjust the power?

Yes. RBA mode lets you set 5-40W manually, while SMART mode chooses an output based on the coil's resistance.

How do I charge it?

Use the USB Type-C cable supplied in the box.

Can I use other PnP coils?

Yes. The pod is compatible with the full range of PnP coils.