Voopoo DRAG X 80W Pod Vape Kit - 2ml, Single 18650

The Voopoo DRAG X 80W pod kit is a refillable pod vape for people who want adjustable power and airflow in a compact, single 18650 device. It pairs a 2ml pod with PnP coils and the GENE.TT chip, and suits vapers who like to tune their setup rather than leave it on a fixed output.

Key features

• Output power of 5-80W, output voltage of 3.2-4.2V
• Resistance range of 0.1-3.0 ohm
• GENE.TT chip with 0.001s ignition speed
• Puff counter and score ranking mode
• Adjustable airflow
• 2ml pod (UK TPD edition) made from PCTG
• Alloy and leather body, 95 x 32.5 x 28mm
• Type-C charging
• Single external 18650 battery, sold separately

The DRAG series is known for fast firing, and the GENE.TT chip keeps that going with a stated 0.001s ignition speed. Voopoo describes the airflow as an infinite system, so you can open or close it to any position and set it to suit the coil and wattage you are using. The body combines metal with a leather finish, which Voopoo says resists scratches, perspiration and fingerprints. Safety protections include short-circuit, overcharge, over-discharge, over-temperature, battery reverse, max power, output over-current and overtime protection.

What's in the box

• 1 x DRAG X device
• 1 x DRAG X pod (2ml)
• 1 x PnP-VM1 0.3 ohm coil
• 1 x PnP-VM6 0.15 ohm coil
• 1 x Type-C cable
• 1 x user manual
• 1 x warranty card
• 1 x chip card

The 18650 battery is not included, so you will need to buy one separately.

Compatibility

The kit comes with two PnP mesh coils. The PnP-VM1 is 0.3 ohm with a 32-40W power range. The PnP-VM6 is 0.15 ohm with a 60-80W power range. For both, Voopoo suggests e-liquid with nicotine up to 10mg.

Choosing your colour

The DRAG X is available in five colours: Carbon Fiber, Dark Knight, Marsala, Mashup and Retro. They all use the same device specification, so choose the one you like the look of.

How to use

1. Fit a charged 18650 battery, following the polarity markings and the instructions in the manual.
2. Fit your chosen coil and let it soak in e-liquid for a few minutes before the first use.
3. Fill the pod without going over the 2ml capacity, then refit it.
4. Set your power to suit the coil, starting at the low end of its stated range, and adjust the airflow to taste.

FAQs

Is the battery included?

No. The DRAG X runs on a single external 18650 battery, which is sold separately.

How do I charge it?

The kit has a Type-C charging port and comes with a Type-C cable.

Which coils come in the box?

You get a PnP-VM1 0.3 ohm coil and a PnP-VM6 0.15 ohm coil, so you can start with either.

What nicotine strength should I use?

Voopoo suggests e-liquid with nicotine up to 10mg for both included coils. UK e-liquid is sold at a maximum of 20mg.