Voopoo ITO-M0 0.5 Ohm Replacement Coils - Pack of 5

These Voopoo ITO-M0 coils are replacement coils for the Voopoo ITO-X pod tank and the Drag Q kit. Each pack contains five 0.5 ohm mesh coils, so you can swap in a fresh one when the flavour starts to fade.

Key features

• Voopoo ITO-M0 replacement coils, pack of 5
• 0.5 ohm resistance
• Mesh coil
• Suggested power range of 18-25W
• Restricted direct lung draw

The ITO-M0 is a 0.5 ohm mesh coil designed to run between 18W and 25W, and it is described as suited to a restricted direct lung draw. Keep your device within that wattage range to get the best from each coil.

Compatibility

• Voopoo ITO-X pod tank
• Voopoo Drag Q kit

How to use

1. Switch the device off and remove the old coil from the tank or pod.
2. Fit the new ITO-M0 coil firmly into place.
3. Fill the tank with e-liquid and let the new coil soak for a few minutes before vaping. This helps prevent a dry, burnt taste.
4. Set your device within the 18-25W range.

Replace the coil when flavour drops, the taste turns harsh or burnt, or the vapour seems weaker than usual. How often depends on how much you vape and which e-liquids you use, as sweeter liquids tend to wear coils faster.

FAQs

How many coils come in a pack?

There are five Voopoo ITO-M0 coils in each pack.

What devices do these coils fit?

They are made for the Voopoo ITO-X pod tank and the Drag Q kit.

What wattage should I use?

The ITO-M0 is listed for 18-25W.

Should I prime a new coil?

Yes. Fill the tank, then leave the new coil to soak for a few minutes before your first draw.