Voopoo ITO-M2 Coils for ITO-X and Drag Q - 1.0 Ohm MTL, 5 Pack

These Voopoo ITO-M2 coils are replacements for the ITO-X pod tank and the Drag Q kit. Each pack holds five 1.0 ohm mesh coils with an MTL draw, so you can keep spares ready for when your current coil needs changing.

Key features

• Pack of 5 Voopoo ITO-M2 coils
• 1.0 ohm resistance
• Mesh coil
• MTL draw
• 10-14W

The ITO-M2 is a 1.0 ohm mesh coil designed for an MTL draw and is intended to be used between 10W and 14W. Buying a pack of five means you are not caught out when a coil reaches the end of its life.

Compatibility

• Voopoo ITO-X pod tank
• Voopoo Drag Q kit

How to use

1. Remove the old coil from your device following the instructions supplied with it.
2. Fit the new ITO-M2 coil firmly in place.
3. Fill the tank and let the coil soak for a few minutes before vaping, so the wick is fully saturated.
4. Keep your device within the 10-14W range.

FAQs

Which devices do these coils fit?

They are replacement coils for the Voopoo ITO-X pod tank and the Voopoo Drag Q kit.

How many coils come in a pack?

Each pack contains five Voopoo ITO-M2 coils.

What resistance are they?

The ITO-M2 is 1.0 ohm and is a mesh coil with an MTL draw.

Do I need to prime a new coil?

Yes. As with any new coil, let it soak in e-liquid for a few minutes before you vape, as this helps avoid a dry, burnt taste.