Voopoo PnP VM1 Coils - 0.3 Ohm Single Mesh, Pack of 5

These Voopoo PnP VM1 coils are 0.3 ohm single mesh replacement coils, supplied in a pack of 5. They suit anyone running a compatible Voopoo kit who wants spare coils on the shelf so a worn one can be swapped out quickly.

Key features

• 0.3 ohm VM1 coil
• Single mesh construction
• Designed for direct-to-lung (DTL) use
• Rated for 32-40W
• Best used with regular e-liquid under 10mg
• Pack of 5 coils

The VM1 is a single mesh coil with a 0.3 ohm resistance, and the recommended power range is 32-40W. Stay within that range for the best results. These coils are made for regular e-liquid, so they are best paired with strengths under 10mg rather than high-strength nic salts. The PnP design is made for a large range of Voopoo kits, and a pack of 5 means you are not caught short when a coil needs changing.

How to use your Voopoo PnP coils

1. Remove the old coil from your tank or pod, following the instructions for your kit.
2. Push the new coil firmly into place.
3. Fill with e-liquid and leave it to soak for a few minutes so the wick is fully saturated.
4. Set your device within 32-40W and take a few gentle puffs before settling into normal use.

FAQs

How many coils come in a pack?

Each pack contains 5 Voopoo PnP VM1 coils.

What power should I use?

This coil is rated for 32-40W. Keep your device within that range.

What e-liquid suits the VM1 0.3 ohm coil?

It is best with regular e-liquid under 10mg.

Will these fit my Voopoo kit?

They are made for a large range of Voopoo kits. Check that your kit takes PnP coils and is suited to the VM1 before ordering.

Do I need to prime a new coil?

Yes. Let a new coil soak in e-liquid for a few minutes before first use, as a dry coil can taste burnt and wear out early.