Voopoo PnP X Coils - 0.3 Ohm Mesh Coil, Pack of 5

These Voopoo PnP X coils are replacement coils for kits built on the PnP X Platform, including the DRAG S2 and DRAG X2. Each pack contains five 0.3 ohm mesh coils, so you can keep a spare or two to hand.

Key features

• Pack of 5 coils
• 0.3 ohm resistance
• DTL / RDL vaping style
• Wattage range of 32-40W
• Ferrochrome and copper coil material
• Thermo stable cotton
• Patented 4-layer leak proof design
• Mesh-distributed heating design
• Automatic production

The 0.3 ohm PnP X coil is a mesh coil designed around a 32-40W range, so set your device within that window. Voopoo describes the heating as mesh-distributed, and the coil uses a patented 4-layer leak proof design with thermo stable cotton.

Compatibility

The PnP X coils are designed for the PnP X Platform series of kits, including the Voopoo DRAG S2 and DRAG X2. If your device is not on the PnP X platform, check before ordering.

How to use

1. Switch the device off and remove the old coil.
2. Fit the new coil firmly into place.
3. Fill the tank or pod with e-liquid and leave the coil to soak for a few minutes so the wick is saturated.
4. Start at the lower end of the 32-40W range and adjust to taste.

Replace the coil when the flavour fades or it starts to taste burnt.

FAQs

How many coils come in a pack?

Each pack contains five PnP X coils.

Which kits do these coils fit?

They are designed for the PnP X Platform series of kits, including the DRAG S2 and DRAG X2.

What wattage should I use?

The recommended wattage range for this coil is 32-40W.

What vaping style is this coil for?

It is listed as a DTL / RDL coil with a resistance of 0.3 ohm.

Do I need to prime a new coil?

Yes. As with any coil, let it soak in e-liquid for a few minutes before you vape, to help avoid a dry, burnt taste.