Wotofo Alien Clapton Pre-Built Coils - 0.3Ohm, Pack of 10

These Wotofo Alien Clapton pre-built coils are ready-made 0.3 ohm coils supplied in a pack of 10. They suit anyone who builds on a rebuildable atomiser and would rather drop in a finished coil than wind each one by hand.

Key features

• Alien Clapton pre-built coils, pack of 10
• Resistance: 0.30ohm
• Wrap: 3*28+36
• Material: N80
• Inner core: 28G x3
• Outer wire: 36G
• Internal diameter: 3mm

The build uses an inner core of three 28G strands with a finer 36G outer wire wrapped around it, which is what the 3*28+36 wrap refers to. Each coil has a 3mm internal diameter, so check that against your atomiser's posts and wicking space before you buy. Because the coils come pre-built, the resistance is set at 0.30ohm and you don't need to wind or measure your own.

How to use

1. Fit the coil to your rebuildable atomiser following the deck's instructions, and check the resistance on your device or an ohm reader.
2. Thread a wick through the coil and trim it so it sits neatly in the wicking channels.
3. Apply e-liquid directly to the wick and let it soak in for a few minutes before firing.
4. Start at a low power setting and adjust upwards as needed, staying within the limits of your device and atomiser.

FAQs

How many coils are in a pack?

Each pack contains 10 Wotofo pre-built coils.

What does 3*28+36 mean?

It describes the wrap: an inner core made of three strands of 28G wire, with a 36G outer wire wrapped around it.

What size is the coil?

The internal diameter is 3mm and the resistance is 0.30ohm.

Will these fit my atomiser?

Check that your atomiser's deck suits a 3mm internal diameter coil and that your device can safely fire a 0.30ohm build. If you are unsure, check with the atomiser's manufacturer.