Wotofo Mesh-Style A1 Coil Strips 0.3 Ohm - Pack of 10

These Wotofo mesh-style A1 coil strips are a 0.3 ohm option for the Profile Series, sold in a pack of 10. They suit anyone who already builds their own coils and wants a flexible strip that works for a single, series or parallel set-up.

Key features

• Mesh-style strip in A1 material
• Resistance of approximately 0.30Ω
• Series dual build of approximately 0.60Ω
• Parallel dual build of approximately 0.15Ω
• Power range of 30W-40W
• 10 strips in the pack

The main selling point is versatility. One strip gives you roughly 0.30Ω, while a dual build changes the final resistance depending on how you wire it: roughly 0.60Ω in series or roughly 0.15Ω in parallel. Whichever way you build, the stated power range is 30W-40W.

What's in the box

• 10 x Wotofo mesh-style A1 coil strips (0.3 ohm)

Compatibility

• Wotofo Profile Series

How to use

Fit the strip following the build instructions for your Profile Series device, and check the resistance on your device or a resistance meter before firing. Fit the wick, then wet it thoroughly with e-liquid and give it a few minutes to soak before you vape. Start at the low end of the power range and adjust from there.

FAQs

What resistance are these strips?

A single strip is approximately 0.30Ω. A series dual build comes to approximately 0.60Ω and a parallel dual build to approximately 0.15Ω.

What power range should I use?

The stated power range is 30W-40W.

How many strips are in a pack?

Each pack contains 10 strips.

Can I use them for a dual build?

Yes. They can be used in a series or a parallel dual build, with the resistances noted above.