Wotofo nexMESH 0.15 Ohm Mesh Coil Strips - Pack of 10

These Wotofo nexMESH 0.15 ohm mesh coil strips are replacement SS316L mesh for the Profile RDA and Profile M RTA. They suit anyone who already builds on a Profile deck and wants a ready-made mesh option, supplied in a pack of 10.

Key features

• SS316L stainless steel mesh
• 0.15 ohm resistance
• 50-80W wattage range, with 65-75W recommended
• Temperature control range of 180°C to 300°C (350°F to 570°F)
• Triple density mesh netting with a micro weave
• Pack of 10 strips

The nexMESH strips use a triple density weave that Wotofo says has three times more holes than standard mesh. The aim is a larger heating surface area, quick heat-up and strong flavour. The micro weave netting is also designed to reduce spit back. At 0.15 ohm, the strips are designed for sub-ohm vaping and for higher wattage devices.

Because the strips are SS316L, they can be used in temperature control mode within the 180°C to 300°C range, if your device supports it.

Compatibility

• Wotofo Profile RDA
• Wotofo Profile M RTA

How to use

1. Fit the strip to your Profile deck, following the instructions supplied with your RDA or RTA.
2. Add your wick and trim it so it sits neatly without being packed in.
3. Soak the wick thoroughly with e-liquid and let it sit for a few minutes before firing.
4. Start at the lower end of the 50-80W range and adjust from there. The manufacturer recommends 65-75W.

FAQs

What resistance are these strips?

They are 0.15 ohm.

What wattage should I use?

The strips are rated for 50W to 80W. The manufacturer recommends 65W to 75W.

Can I use them in temperature control?

The SS316L mesh is rated for a temperature control range of 180°C to 300°C. You will need a device with a temperature control mode.

How many strips come in a pack?

Each pack contains 10 nexMESH strips.