Wotofo OFRF nexMesh 0.13 Ohm Mesh Strips - Pack of 10

These Wotofo OFRF nexMesh 0.13 ohm mesh strips are rebuildable replacement mesh for the Profile RDA, supplied as a pack of 10. They suit vapers who already build or fit their own coils and want a low-resistance mesh option for higher-wattage sub-ohm setups.

Key features

• Pack of 10 mesh strips
• 0.13 ohm built-in resistance
• Recommended wattage range of 60W to 70W
• Triple density mesh structure
• Kanthal A1 mesh measuring 16mm by 6.8mm
• Micro weave netting for a greater surface area

nexMesh is Wotofo's triple density mesh, made for its Profile series of rebuildables. The micro weave netting gives a larger heating surface area, and Wotofo describes it as aimed at intense flavour and quick heat-up, with the weave designed to help reduce spit back. At 0.13 ohms it is intended for sub-ohm use on devices that can run at higher wattage, so stay within the 60-70W range.

Compatibility

• Wotofo Profile RDA

Choosing your Wotofo nexMesh mesh strips

This listing is for the 0.13 ohm strips only, sold in a pack of 10. There are no other resistances or options to choose from here.

How to use

1. Fit the mesh strip to your deck following Wotofo's instructions for your atomiser.
2. Wick the strip and soak it thoroughly with e-liquid before firing.
3. Check that your device is set to a safe output for 0.13 ohms, and start at the lower end of the 60-70W range.
4. Replace the strip when flavour drops or it looks worn or burnt.

FAQs

How many strips are in a pack?

Each pack contains 10 nexMesh mesh strips.

What wattage should I use?

The recommended range is 60W to 70W for the 0.13 ohm strips.

What size are the strips?

The Kanthal A1 nexMesh strip measures 16mm by 6.8mm.

Which atomiser are they designed for?

They are designed for the Wotofo Profile RDA.

Do I need to prime a new strip?

Yes. As with any new coil, wick it and let it soak in e-liquid before you fire it, so it does not dry burn.