Wotofo Profile Mesh RDA 24mm - Rebuildable Atomiser

The Wotofo Profile Mesh RDA is a 24mm rebuildable dripping atomiser designed by Wotofo in partnership with MrJustRight1. It suits experienced vapers who already build and wick their own coils and want a deck that takes both mesh and wire builds. This listing is for the Ultem version.

Key features

• 24mm x 32.5mm RDA body, made from stainless steel
• Wide clamp posts with side securing for mesh or wire coils
• Spring-loaded ceramic support at the centre of the deck
• Beehive-style air inlets on the RDA sleeve
• Mesh coil sheet in Kanthal A1, 16 x 6.8mm, 0.18 ohm
• Recommended wattage for the mesh sheet: 40-60W
• Bending tool included for shaping the mesh sheet

The deck is the main talking point. The spring-loaded ceramic support sits in the middle and is there to keep the cotton pressed against the mesh, so the wick does not slump away from the coil once it is saturated. The posts clamp from the side, which makes fitting a mesh sheet or a wire coil fairly straightforward, and you can switch between the two as you prefer. Wotofo designed the Profile with flavour in mind, and the airflow inlets are matched to the deck layout.

What's in the box

• 1 x Profile RDA
• 1 x user manual
• 1 x 6mm agleted cotton strip
• 1 x bending tool
• 1 bag of Clapton coil
• 1 bag of mesh style coil sheets
• 1 bag of extra O-rings and screws

Choosing your option

This page offers the Ultem version of the Profile RDA.

How to use

1. Fit your chosen coil (mesh sheet or wire) onto the deck and secure it in the clamp posts. Use the bending tool to shape a mesh sheet so it heats evenly.
2. Fit the wick so it makes good contact with the coil, and trim the ends.
3. Wet the wick thoroughly with e-liquid and let it soak in before firing.
4. Check the resistance on your device, and keep within the recommended wattage for the coil you have built.
5. Re-wet the wick as it dries out, and replace the coil when the flavour fades.

FAQs

Does the Profile RDA take wire coils as well as mesh?

Yes. The deck uses wide clamp posts with side securing and accepts both mesh and wire coils.

What wattage should I use with the mesh sheet?

The mesh coil sheet is 0.18 ohm Kanthal A1, with a recommended range of 40-60W.

How big is it?

The RDA measures 24mm in diameter and 32.5mm in height.

Is it ready to vape out of the box?

No. It is a rebuildable, so you need to install a coil, wick it and soak it with e-liquid before use. A bending tool and cotton strip are included to help.