Wotofo Profile RDTA Rebuildable Tank - 25mm, 2ml

The Wotofo Profile RDTA, designed with Mrjustright1, is a 25mm rebuildable tank atomiser with a 2ml capacity. It suits vapers who already build their own coils and want a deck that takes both mesh and wire builds. It also converts to an RDA with the adapter in the box.

Key features

• 25mm diameter, 52.7mm tall (without the 510 pin)
• 2ml e-liquid capacity
• 22.5mm build deck with postless clamping
• Single mesh coil, single wire coil or dual wire coil builds
• Wattage range 60-80W, recommended 70-75W
• Adjustable side airflow with a honeycomb intake
• 810 coloured resin drip tip
• German PEEK insulator and 510 threading
• Mid filling as an RDTA

Liquid is moved up to the coil by four pre-installed stainless steel wicks, shaped like a rope. The postless deck takes two 3mm inner-diameter wire coils or a single 3.5mm inner-diameter coil. Airflow is set by turning the top cap.

What's in the box

• 1 x Profile RDTA
• 1 x nexMESH Clapton Ni80+A1 0.2 ohm strip
• 1 x nexMESH Extreme A1 0.16 ohm strip
• 1 x nexMESH Turbo A1 0.13 ohm strip
• 2 x Framed Staple Clapton Ni80 0.33 ohm pre-built coils
• 2 x 6mm cotton and 2 x 3mm cotton
• 6 x stainless steel wick (4 pre-installed, 2 spare)
• 1 x coil trimming tool
• 1 x mesh bending tool
• 1 x RDA adapter
• 1 x cross head screwdriver
• 1 x allen key
• 1 x accessory bag
• 1 x user manual

Compatibility

The Profile RDTA works with all Profile 1.5 RDA mesh strips. It has a standard 510 thread, so it fits any 510 device.

Choosing your colour

The Profile RDTA is available in Black, Blue and Gun Metal. The drip tip is coloured resin. The colour is the only choice to make, as the specification is the same on each.

How to use

Fit your chosen coil to the deck, trim the leads and make sure the coil sits clear of the deck. Thread the wick through, then wet it with e-liquid before you fire. Let it soak for a few minutes. Fill through the mid-fill opening without going over the 2ml capacity. Start at the lower end of the wattage range and adjust from there.

FAQs

Can I use the Profile RDTA as an RDA?

Yes. Remove the tank section and screw the supplied RDA adapter onto the bottom of the deck. You can then choose a standard or bottom-feed 510 pin. Bottom-feed (squonk) filling is used in RDA mode.

What coils can I build?

The deck takes a single mesh coil, a single wire coil or dual wire coils. The pack includes three nexMESH strips and two pre-built Framed Staple Clapton coils to get you started.

What wattage should I use?

The range is 60-80W, and the recommended range is 70-75W.

How much e-liquid does it hold?

This UK version holds 2ml.